Overview
Start and stop a screen recording directly within ArborXR Home or ArborXR Kosk Mode. Screen recordings captured via ArborXR are saved on the device to /sdcard/ArborXR/ScreenRecordings
.
Supported Devices
This feature is supported on the following devices:
Meta Quest 2
Meta Quest 3
Meta Quest 3S
Meta Quest Pro
PICO 4 Enterprise
PICO 4 Ultra Enterprise
HTC VIVE XR Elite
HTC VIVE Focus Vision
VIVE Focus 3
PICO G3
Lenovo VRX
PICO Neo 3 Pro
PICO Neo 2
PICO G24K
Steps to Record Screen
Within the device or group's Headset Experience settings, check the Screen recording (shown in quick-access menu) checkbox and apply changes.
Within ArborXR Home or kiosk mode, press the home button to open ArborXR's quick access menu then select Start Screen Recording.
On certain devices, such as Quest devices, PICO 4 Enterprise and VIVE Focus 3, a system dialog will open prompting users for permission to start the screen recording. Users must select Start Now.
Meta permission dialog:
PICO permission dialog:⚠️ If users select Cancel, the device must be rebooted for this dialog to open once more.
Once done recording, press the home button to open ArborXR's quick access menu then select Stop Screen Recording.
💡 Screen recordings captured via ArborXR are saved on the device to /sdcard/ArborXR/ScreenRecordings
.
Alternative Recording Method on Meta Quest
By default, the Oculus (‘O’)/Meta Home button is mapped on the right-handed controller. If using an alternate home button mapping on the left-handed controller, substitute its Menu button (three vertical lines) for the Oculus (‘O’)/Meta Home button in the steps below.
Screenshot:
On the right-handed controller, quickly click and hold the Oculus (‘O’)/Meta Home button, then immediately press and release the front trigger on the controller. You will hear a camera shutter sound and see an in-headset notification to indicate that a screenshot was taken. It should disappear within a few seconds.
Screen recording:
To Start a recording, press and hold the Oculus (‘O’)/Meta Home button on the right-hand controller, for about 1 second, and no longer, then press and hold the front trigger button. Wait until you hear a tone and notification from the Quest OS, then release the buttons. In the upper right corner of your field of view, a yellow dot will first appear, followed shortly after by a red dot, indicating the recording is active.
To Stop the recording, repeat the same button presses above. Once completed, the Quest device will sound a tone, and an in-headset notification from the Quest OS will indicate that the recording was saved to your Quest device. It should disappear within a few seconds.